"Providing Excellence Since 1981"

RISER TOOLS

CRP-150MR6 Riser Tool Package

The Clover Tool Company CRP- I 50MR6 Riser Tool Package contains all the tools a rig needs to operate the latching dogs/bosses on the MR6 series riser rapidly, safely, and with virtually no damage to the dogs/bosses on the riser itself Instead of using an impact- type wrench that hammers the running screws during both operations (running and pulling) the CRP-150MR6 Riser Tool Package contains two (2 ea) air operated torque wrenches with a two speed automatic (High-Low) gearbox, that runs the dogs in at a comfortable, safe speed (45 rpm) and when the dog is snug, gears down to 9 rpm to finish the torquing procedure. Once at the preset torque level, this tool stalls and has just enough power left to turn the rundown screw to allow the locking plate to set.

With this operation, the need to follow up with a manual torque wrench to check torque is negated, making the job faster, safer, and more accurate, since most checks done with the manual torque wrench are done to check that enough torque is applied, very rarely checking to see if too much torque has been applied, which is very damaging to the equipment, both tools and riser.