HOME

RISER TOOLS

• HRT-15 HYDRAULIC
RUNDOWN TOOL

• Up to 40,000 ft. lbs. of torque
• Torque and speed tailored to customer requirements
• Totally self-contained
• Uses rig hydraulics without hydraulic console or booster control system
• Decades of proven reliability and customer satisfaction
• Over 80% market share

The Clover Tool Company CRP-MR/DT-M72/2K-3 Riser Tool Package contains all the tools a rig needs to operate the latching dogs/bosses on the MR6 & DT Series Riser rapidly, safely, and with virtually no damage to dogs/bosses on the riser itself. Instead of using an impact-type wrench that hammers the running screws during both operations (running & pulling), the CRP-MR/DT-M72/2K-3 Riser Tool Package contains three (3 each) lightweight air operated torque wrenches with two-speed automatic (High-Low) gearbox, that run the dogs in at a comfortable, safe speed (70 RPM) and when the dog is snug, gears down to finish the torquing procedure. Once at the preset torque level, this tool stalls and has enough power left to turn the rundown screw to allow the locking plate to set.

With this operation, the need to follow up each actuator screw with a manual torque wrench is negated, making the job faster, safer, and more accurate, since most checks done with the manual torque wrench are done to check that enough torque is applied, very rarely checking to see if too much torque has been applied, which is very damaging to both tools and riser.

With a maximum torque rating of 1475 ft/lb., this tool has the power for both makeup and breakout of most dog-type riser joints. Its light weight (14lbs) and speed (70 RPM), make it a great asset for most dog-type Riser Operations.

• Connects directly to rig hydraulics
• Eliminates need for heavy impact wrenches
• Lightweight, dependable and fast
• 1 ½ inch square drive for standard sockets or with a spline drive
• Operates up to 450 RPMs depending on flow and pressure